Well its that time again... so whats it going to be this year? You know.. so and so's car was sooo much faster on the straight than mine they had to be cheating. Last year it was timing so they wont use that... maybe tuning ESC's with laptops and secret go fast programing... or maybe super cheater Lipo's in legal cases :rolleyes:
Cant wait, always great reading for a few weeks :woohoo:

it has been a very fair week so far. why start something that doesnt need to happen

it has been a very fair week so far. why start something that doesnt need to happen

What fun is the internet with out drama ;)
Look back... every year its the same thing... a week of bitching... and good reading :lol:

Behler was so fast, he must have been cheating, lol
Just kiddin big Al. by the way nice work down there.
2 TQ's not too shabby

Can anyone tell me what numbers they were using to tech motors for resistance? I know the minimum on a 21.5 was 53. What about the 17.5 and 13.5 motors?

Can anyone tell me what numbers they were using to tech motors for resistance? I know the minimum on a 21.5 was 53. What about the 17.5 and 13.5 motors?


17.5's were 39-33 for the spec due to it being open motor brands. I am not sure what the spec on 10.5s was as I didnt run that class.

I ran Novaks in both cars. 21.5 was 58-59 on each pole and 17.5 was 36-37 on each pole.

EA

Good deal. i just got some new stuff in and wanted to see how far off they were. My 21.5 was down there with someone else and ended up getting pulled because the number on one pole was just a tenth below minimum.

It's always entertaining to read all the trash and such after a big race. So far things are quiet, but i suppose thats because not everybody is home yet. :jest::roll:

Out of curiosity since 17.5 was an open motor class, did one motor seem to dominate or one motor/esc combo just light it up ?

Most used Novak. Terry Z and I ran Duo's.

Adam

It's always entertaining to read all the trash and such after a big race. So far things are quiet, but i suppose thats because not everybody is home yet. :jest::roll:

lol, we are home and do not have any dirt for you. Guess you are going to have to watch Jerry Springer for your jollies...

ohms right?17.5's were 39-33 for the spec due to it being open motor brands. I am not sure what the spec on 10.5s was as I didnt run that class.

I ran Novaks in both cars. 21.5 was 58-59 on each pole and 17.5 was 36-37 on each pole.

EA

ohms right?

Micro henries or what ever they use to measure them. They were measured from ABC to the node ring. This method checks each pole by its self to prevent people from removing one strand or wrap from the motor.

EA

Thanks Eric

i think 13.5 was 19-23. could be wrong, but mine was 22. not exactly on the low end of the range, but still performed very well.

lol, we are home and do not have any dirt for you. Guess you are going to have to watch Jerry Springer for your jollies...

LOL...Thats funny!!!