View Full Version : Need Info. On Wheelhorse Tractor


Dimark1009
12-28-2008, 04:58 PM
I have a Wheelhorse tractor in the shop for service, I need a couple of parts and cannot find anything on the net.

The tractor is a 12 HP and a small metal tag has ID# 01-12K803-24713 and underneath that is the numbers 1356.

Thats really the only numbers I could find on the tractor , the engine is a Kohler K301.

I need a couple of belts and the spring that returns the clutch pedal.

I looked on Toro's website but it wasnt any help.

If anyone knows where I can find a parts breakdown or list I'd appreciate it.

Thanks in advance..

Mark

paulr44
12-29-2008, 12:08 AM
Mark, it is listed in their public site:
https://lookup3.toro.com/partdex/index.cfm?xCaller=Toro
DON'T EVER scrap that unit - it'd cost you at least like $5000.00 to replace a garden tractor of that caliber, and someone would probably be interested in it. Built like a brick s##thouse.
Paul

Dimark1009
12-29-2008, 08:54 AM
Thanks Paulr44, Thats what i was looking for.

stan
12-31-2008, 02:53 AM
I pasted this problem in the 2 cycle section, probably the wrong place.Here is my problem. The mower is a Honda Harmony HRB 215. It will only start when gas is squirted in to the carb intake, and will only run for 10 seconds. Here is what I checked so far.Float boll has good suppluy from tank, and fills with gas ok. Checked main jet, and it is clean. Anyone have any ideas? Thanks stan

dj722000
01-05-2009, 01:16 PM
You dont have gas going through main nozzle and or your bowl retaining nut which has a little hole in it, (fuel metering port) is plugged. Use choke cleaner and compressed air to blow out all passages in carb including the bowl retaining nut. Sometimes the wire off a little tag card you can poke through the little holes to help clean them.