dandor
08-05-2008, 07:33 AM
Hello,
This is my first post! I enjoy tinkering and working on engines to save being ripped off, but I am stumped and hoping to get help here. I have a Craftsman Blower Vac model 358.794960. I have used this for a few years and been very satisfied for the money. I was shredding ivy, and jammed the impeller. unjammed it and restarted, but then jammed again under weak load. Then would not start. I replaced the plug and ignition module. I have spark, but it will not run even with starting fluid. I don't have a compression tester, but am at least getting some compression. Pulling rope feels normal. No visible marks on pistion. It seems like the next logical thing from what I've read on this site would be the flywheel key, however, I am unable to locate this part or anything similar in the repair parts pics. Any suggestions or help?
Thanks,
Dan
This is my first post! I enjoy tinkering and working on engines to save being ripped off, but I am stumped and hoping to get help here. I have a Craftsman Blower Vac model 358.794960. I have used this for a few years and been very satisfied for the money. I was shredding ivy, and jammed the impeller. unjammed it and restarted, but then jammed again under weak load. Then would not start. I replaced the plug and ignition module. I have spark, but it will not run even with starting fluid. I don't have a compression tester, but am at least getting some compression. Pulling rope feels normal. No visible marks on pistion. It seems like the next logical thing from what I've read on this site would be the flywheel key, however, I am unable to locate this part or anything similar in the repair parts pics. Any suggestions or help?
Thanks,
Dan