I am looking for a picture of the governor linkage for a Tecumseh 3.8 hp H35 engine. I took the carburetor off and disconnected the linkage, then forgot which hole it connected to on the carburetor plate.

I cleaned the carburetor to try and correct the engine from hunting/surging when you first crank it. After it warms up it runs smoot.

the linkage that goes from the govenor to the carb going into the hole farthest outside corner......least thats the best I an describe it

Maybe yours is in the link below. Have a good one. Geo
http://i190.photobucket.com/albums/z120/geogrubb/TecLinkage-tvsgov.gif

Have you downloaded the Tecumseh L head service manual and checked out the linkage diagrams there? You can find the link to the manual in the "Helpful Links" Sticky post at the top of this 4-cycle forum. No charge!

FYI...