What Is The Fix For Ntc3 Or Tc3 Diff Cases To Stop How Easy They Break.is There A Stronger Aftermarket Case.what About A Brace.thanks Rod

What are you breaking on the diff case?

Look online/ebay for aluminum TC3/NTC3/TC4 diff cases. Sometimes they are listed/described as blueprinted cases.

Found a link to an online store that has some (as an example). I have never used this site, so I cannot guarantee that they are reputable. (http://www.rdlogics.com/cgi-bin/category.cgi?item=81381&type=store)

I have personally seen aluminum diffs cases and installed some of these cases on a NTC3 that I was helping someone to sell. I have never raced with them, but you may have an issue of breaking off screws in the aluminum case versus breaking/stripping the plastic case.

Hope this info helps.

IT'S CRACKING AT THE SCREW BOSSES.I TRIED THE RD LODGIGS ALUMINUM ONES AND THE BOSSES BOKE UNDER CORNERINGWhat are you breaking on the diff case?

Look online/ebay for aluminum TC3/NTC3/TC4 diff cases. Sometimes they are listed/described as blueprinted cases.

Found a link to an online store that has some (as an example). I have never used this site, so I cannot guarantee that they are reputable. (http://www.rdlogics.com/cgi-bin/category.cgi?item=81381&type=store)

I have personally seen aluminum diffs cases and installed some of these cases on a NTC3 that I was helping someone to sell. I have never raced with them, but you may have an issue of breaking off screws in the aluminum case versus breaking/stripping the plastic case.

Hope this info helps.

you gotta be cranking em to tight ice !!

you gotta be cranking em to tight ice !!

TRIED THEM TIGHT AND ALITTLE LOOSE

Iceman, When I raced Nitro a few years ago at Classic i made my own little like X brace, out of 3 little pieces of steel and some jb-weld

Are you guys running foams or rubber?

Iceman, When I raced Nitro a few years ago at Classic i made my own little like X brace, out of 3 little pieces of steel and some jb-weld

Are you guys running foams or rubber?

FOAMS.WE FOUND A WAY TO PUT A SCREW ALL THE WAY THROUGH THE DIFF CASE AND UP THROUGH THE SHOCK TOWER THEY ARE BULLET PROOF

What is breaking on the diff case? On the pastic cases, I put heli-coils in all the holes since the rebuilds wear out the threads quick. Don't use aluminum screws except for the 6 holes that couple the two halves.

I have some TC3 aluminum diff cases(Not sure if they are Nitro), $25 shipped and they can be yours.