Have to a B&S 6 hp when I start it I use the primer bulb, it then starts and runs for 10 seconds and stalls out if I contin the p[rue to do this over and over about 6-7 time it finally starts, and runs good, when ho there is no problem
Any ideas what the problem is here ?? and a fix?

Thanks!

Does this carb have a bowl on it ? If it does try removing the carb carefully then pulling the bowl off carefully trying not to stretch the rubber bowl gasket. take it apart and clean everything really good use the wire out of a bread tie and run it through all the jets and make sure you clean the jets on the brass bolt that you pull off to remove the bowl should be 2 little holes at the bottom of it. Then reassemble and you should be good to go.

That did it thanks Phillip!! !!