Is there a way to remove the car from the blister without tearing the damn thing apart? I had to take a knife to open my vettes:p

Thanks:thumbsup:
Peter

That is pretty much how it is done...lol. I have used an exacto to slice around the back on a few of mine. A couple of my GM's needed some attention. By cutting around the back I can put the car back in.

That is pretty much how it is done...lol. I have used an exacto to slice around the back on a few of mine. A couple of my GM's needed some attention. By cutting around the back I can put the car back in.

ok then the knife it is! :D
I can't say I don't have fun doing it! :woohoo:

Thanks!
Peter

I take a pair of scizzors up both sides of the car. Then cut across the bottom.
In fact I just did 36 of them.