Hey Guys
Is there any special maintance that i could do to the motor to abtain high preformance and smooth operation..

Nope. Just put it in your car and go. Maybe a drop of oil on the bearings every couple months.

He's one of the guys you want to listen to, Taylor... :thumbsup:

I haven't even oiled my bearings on these things, ever. Maybe I should, but they hold up pretty good.just keep the solder tabs clean when you remove the motor.

I remove my bearings clean them and lightly oil them then wipe off excess oil and use air (very lightly) to blow out the can DO NOT USE MOTOR SPRAY this will damage the sensors inside. I only do this when I get bored LOL..
Remember the sensor based motors are prettymuch sealed and there is not much crud in there to get in your bearings like you had with brushed motors so there realy is no need to do this on a regular basis.