i have no idea as to what to do with this thing..any input would be nice..thanks guys..

http://img.photobucket.com/albums/v139/addicted2164z/bus1.jpg
http://img.photobucket.com/albums/v139/addicted2164z/bus2.jpg
http://img.photobucket.com/albums/v139/addicted2164z/bus3.jpg

woho ..let me think on this one.

Try your hand at bodywork and put it all back! Seirously, leave the body line, fill and smooth all the rest of it. Hey, just a thought. Don't know what you were doin with the roof but it looked kind-of cool. Good Luck.

Slap on some window screening instead of the body panels so you can see the engine and detail it.

Fill flames and sides with coloured translucent plastic and add an LED and button cell to light it up.

Get 'er done!........................................:thum bsup:
Seriously, it looks amazing, just needs pieced together, detailed.


Jeff Fleetwood

I like the flames in the top. I think that turning the holes into "windows" would be pretty sweet, as everyone else has mentioned. But I'd keep those flames on the roof!

HUGE headers out the sides angling up towards the roof :thumbsup:

I like the idea to fill the roof with a tinted clear plastic to make it look like a custom sun roof. The sides need to be filled back in and maybe a port hole window left to see a detailed engine.

In the words of Tim Gunn - Make it work!!

What's the whole story on this piece?
A lot of very good Jewsaw work on this piece.
Did You do the work on it? Maybe bought it this way? I 've seen the cutout flame licked roof somewhere before.
I think from the sounds of the replies people think You got it this way, and are looking to improve,maybe restore it?...
It struck me the opposite,..I figured You had done the body mods & was looking for ideas to finish it....Which is the right answer?


Jeff Fleetwood

hi jnk.. i did the mods myself and i did another one something like it a few years back but with a little different flames. i am just stuck with what to do with it and ran out of ideas. i was going to go on the chassie that the bone shaker is siting on but that ga axed after i set the bs body on it. so now i need to get this one going again or it gets junked. anyways thanks for any and all ideas guys and all the comments on the rest of the cars also.

later..

add

Man.. the top looks way cool! Too bad the sides are non-existent. If you decide to scrap it, use the chassis with the new dodge van body and swap over the spoiler too.

Fill in the rear exhaust port and run the exhaust out both sides - that will give you use for the large opening and still allow one to see the rest of the detailed motor around the pipes...........

Just an idear..............