how do you do the after run proceder and what i need. do i need to do it
even with a nitro evader

take the glow plug out and take some after run oil or i use a mixture of half transmission fliud and half marvel mystery oil and put a few drops down the glow plug hole and a couple down the carb. opening.and if you have pull start give it a couple of pulls to circulate oilin motor or if you have starter box turn over motor this way just dont put glow plug igniter on the plug we dont want this to start or get fuel in carb.you should be good to go. the nitro in fuel if left in engine can cause moisture in the motor and actually can rust and gum up motor.so this is a good idea after your done with your nitro vehicle.just when you start up to use it might smoke and be a little rich till you burn off after run oil then get ready to rip.

can u use wd 40 do u need to do it with all nitro vehicles

Use Marvel's

wd 40 works good too, its flamable, so it will burn out when you fire it up. the after run oil ( trans fliud ) is not flamable, so it could and will foul a glow plug on start up from time to time. you just need to do something to get a coating in there, so it does not flash rust the case and bearings. if you run extra oil in your nitro fuel, you may not have to do it. id run 30% wildcat and add 4 oz's of benoil and the inside of my motors always looked new and i never used after run, just cause i was lazy. but when i ran nitro, i raced every week, so my stuff did not really sit around.

will doing the after run process help me start the next day