Simple one -- painted the rear wing white and added West decals from Pattos.

http://photos.hobbytalk.com/data/500/medium/DSC02452.JPG
http://photos.hobbytalk.com/data/500/medium/DSC02453.JPG

The meatball #9 came from Rob's Modeling on fleaBay.

:thumbsup::thumbsup:

Wes

and whistle clean. Perfect fit for the body. :thumbsup: nd

Doba,

Nice to see neat cars like this on a scenery layout. That car is Lookin" good man! :cool:

Bob...zilla

'Doba

Where did you get that guard rail from. I bet I could make resin versions if I can get my hands on some donors.

'Doba

Where did you get that guard rail from. I bet I could make resin versions if I can get my hands on some donors.

I used 1/32 Scalectric (or was it Carrera?) guardrail and just cut the posts down shorter. I hot glued a nail to the backside and drilled a hole through the table-top to slide the nail into. Worked great.

Here's a pic:

http://photos.hobbytalk.com/data/500/medium/Deckertring2007-_165.jpg

I set the post height at right about track height.

On my track I used the white plastic molding for the 'modern' areas of the track and I used the guardrail for the 'old circuit' areas, like heading into the forest section.

http://photos.hobbytalk.com/data/500/medium/HOCC-Deckertring2007-_006b.jpg

I'm impressed by the hump bridge on your layout :thumbsup:

Richard