Just goofin' around with this NSX. Here is the diecast before and a resin after. It's sitting loosely on a SG+ chassis. Should be a cool car once I get the mold down.

Now....if I could finish one project before I start goofing around with another? :freak:

That's looking good - hope you get to finish it off and post the final pics!!

Cheers

Richard

Just goofin' around with this NSX. Here is the diecast before and a resin after. It's sitting loosely on a SG+ chassis. Should be a cool car once I get the mold down.

Now....if I could finish one project before I start goofing around with another? :freak:

LOL! story of my slot life......and most of the guys here! Just gotta keep at them! :thumbsup:
Nice looking body....if you go for something that looks cool..........and swoopy...........and fast.........and expensive....and......... ;)

Sweet! That would look beautiful in a Nichi-Ra scheme. Nice work.

Should look pretty good once you get the dremeling done. :cool:

Nice casting. :thumbsup: :thumbsup: rr

pouring a few bodies to close the wheel openings in for the Tomy. I also cut the male part of the mold to give the body more rigidity. It was very thin around the rear decklid and the rear end would snap in a heartbeat. I was able to get a few 1/64 diecast which only look to be available overseas. I will have to see what Pattos decals I can make work. I have a bunch of DTM liveries that should look good on this body.

Now......get back to your GTP bodies Gary!!!

I'll take one of those first casts, bare and unfinished. I have some ideas for that. :D

I'll take one of those first casts, bare and unfinished. I have some ideas for that. :D


Once I have it opened up for the Tomy wheelbase....no problem.