I own one of the older Corally Tire Sizing Lathes. Recently I lost some of the adapters that allow for the user to cut down different types of tires; i.e 1/10 1/12 scale, etc. Someone reccomended that I purchase a new arbor from Lefthander RC, which I did, however I cannot remove the "old" arbor from the shaft on the lathe! Anyone have any ideas?.........Thanx! :thumbsup:

Try to heat it. Maybe with a blow dryer or a propane torch. The aluminum should expand faster then the steel shaft. You won't have to get it super hot.