Does anyone make an adaptor for this truer for pan car tires? It doesn't look like integy has one.

Integy Tire Truer (http://www.integy.com/cgi-bin/webc.cgi/st_prod.html?p_prodid=2334&p_catid=57&sid=7UzLO41kpMQW3Pb-13107084300.66)

Thanks

This one should fit and will fit most 1/10 and 1/12 pan car tires.

No link?

Thanks

I use the one from rc4less.com and it works good.

http://rc4less.safeshopper.com/5/210.htm?289

I have used the Hudy arbor for a while. It works well

i just bought the integy one and had it turned on a lath to fit front and rear pan tires.works fine.

the rc4less one works great!!

Thanks everyone, I would of never found that!

Gregg

I have that Integy truer. I had the Hudy, but the stud doesn't fit front tires. I got the RC4Less, it is the best!

put on the rc4 less arbor and get a carbide blade and then you have a tire truer that works awesome

I'm not sure that I like the RC4less arbor especially when it comes to the rear tires. The end farthest from the motor flops around in the breeze a little bit. There is nothing the centers that end. You can loosen, reposition, retighten, and repeat and you'll see a lot of difference.