Hello All :)

I am having a problem with the receiver in my plane. I turn on my controller then I plug in the battery to my plane. After that the rudder, elevator, everything begins to twitch (move on its own). If I turn off the controller everything stops. After several minutes of doing this the reciever seems to learn what it is supposed todo and begins to works. If I unplug the planes battery for ~1min and plug it back in the receiver retains is memory. But if I unplug it for several minutes then it looses its memory again. Is there a way to fix this??

Thank You
Aaron :confused:

re-seat the tx and rx with the power removed then re power and try

Hello,
Thank you for replying

I tried removing then placing back in the crystals and nothing changed.

I am still not sure what the Exact problem is, But I just powered up the transmitter then receiver about 15 minutes ago. I did not touch anything on it except for the controls on the transmitter. It twitched for a while then as I was moving the controls it started to slowly begin to work. After about 10 min the plane began to work fine. Almost as if it is a temperature issue, but instead of heat making the ecletronics worse, it actually makes it better . I am sure it will be a problem again after I disconnect the battery for a while and try to reconnect it.

In the end I am probably going to get a new receiver/crystal, its just VERY odd how this is reacting.
Ohh, BTW this plane was a gift "SkyArtec Cessna 182". I researched it, its a China made RTF. Will MOST likely upgrade to a new system all together when I get the money

Thank You Again....
Aaron