Im curoius on the setting people use for the sphere in 13.5 classes.. Ive basically never touched them.. i just run it how i bought it..

...hey, that's how we run our 5.5 and 4300...

out of the box is great.................. :thumbsup:

I don't know much about th sphere, but if it comes out of the box with drag brake I would turn that off.

Here's the setting I used with my Sphere Comp with a 13.5;
Mode 1: Value 2
Mode 2: Value 6
Mode 3: Value 1 or 2
Mode 4: Value 0

It is very important to have Mode 1 set to value 2 if you are using 4 cell NiMh's. Otherwise you could experience a shutdown because the ESC will see a low voltage condition, assume you are runinng LiPo's and shutdown. At least this "was" an issue with the early LRP Sphere COMP's.

The rest of the settings; Mode's 2 - 4 are drivability settings.

The non-COMP version does not have all of these settings, but I believe it does have some setting like the Mode 1.

Original Sphere ,I set mine on the modified setting no drag brake.

Jake

Hey Burbs,

My Sphere is set at:

Mode 1--2 (no rev.)
Mode 2--3 (modified)
Mode 3--2 (medium brake) adjust for your preference
Mode 4--0 (no auto brake)

I used the same settings for 4300 and 13.5