What size drill should I use to drill screwposts on Tjets bodies???

Thanks,
Jerry

Hello, try a 1/16th bit in something and see how your screws fit, that's what I use, Jimmy

I like to take a small screw driver and heat the tip and melt in a hole. Hasn't failed me yet

Hi Jerry. First I check the chassis mounting tab alignment front to rear with the wheels properly centered in the wells, and then check the body spacing side to side at the rockers (I've doofed it too many times!) Then I do the Texas Two Step. I drill a pilot hole. Then I follow with a 1/16. All with the pin vise of course.

Doesn't RRR make a first time every time self aligning gizmo for doing this?
Bill

PS: VJ plays with fire. HeHeHe, Me Too!

i think rrr does make something for this i always see it in with the chassis page