I am re-building a 5 hp B&S (model 132232) with a Pulsa-jet carb (circa 1991). I am installing a new throttle valve (old one was bent beyond repair.) The new valve plate has a center hole for mounting to the throttle shaft and 2 metering holes. One is larger than the other. What is the correct orientation of the metering holes in the bore?

If you send me your email address, I will email you the carburetor section of the service manual that covers your model.

Does your throttle plate have a stamped mark or letter in it? The only thing I could find shows a stamping on the throttle plate and it is placed in the 3 o'clock position when looking straight down the carburetor throat.

BTW why did you start this thread over again?

e-mail address is ksimback@cfl.rr.com. Thanks for your help.

Re-post was a rookie mistake. First time poster. Couldn't find my original.

Ken

No mark or stamp on the throttle plate by the way.