Hey everybody
I have a tecumseh h50 with a series 1 carb. It was running fine, then i was repacing the muffler and might have hit the carb. But anyways it will not run now, i have reset all mixture settings, it will fun for a few seconds with some starter fluid. Gas is getting to the carb. Not sure where to go from here. Please help.

Thank You

What exactly did you hit? the fuel bowl? did it get dented maybe?

Yea the bowl has a small dent on the left side, and the low speed mixture screw is slightly bent, could that be the cause? Also when i push in the button on the bottom fuel does not come out. What do you think would need to be replaced?

Thank you