Hey brushless folks, for those of your with "sensored" setups like the Novak system who don't need all that extra sensor wire (for example many on-road applications have the ESC right next to the motor) has anyone come up with a good way to cleanly shorten those leads?

Since the wires are so small and the connectors proprietary, I'm reticent to ever clip them, plus I fear never getting support from Novak again if I did that. Anyone know if it's possible to disconnect the motor end inside the motor someplace and purchase a shorter harness from anyone?

These wires are so fragile and tiny, and of course I have the included plastic wire loom wrapped around them, but they're so darn long and annoying and get in the way, I'd really like to clean up my car a bit. What do the pros do about this?

Hey brushless folks, for those of your with "sensored" setups like the Novak system who don't need all that extra sensor wire (for example many on-road applications have the ESC right next to the motor) has anyone come up with a good way to cleanly shorten those leads?

Since the wires are so small and the connectors proprietary, I'm reticent to ever clip them, plus I fear never getting support from Novak again if I did that. Anyone know if it's possible to disconnect the motor end inside the motor someplace and purchase a shorter harness from anyone?

These wires are so fragile and tiny, and of course I have the included plastic wire loom wrapped around them, but they're so darn long and annoying and get in the way, I'd really like to clean up my car a bit. What do the pros do about this?

shorten up the wires and heat shrink them..