PDA

View Full Version : Savage motor rebuild cost

savage 14
10-08-2005, 01:46 PM
dose any one know how much a piston and sleeve is for stock savage 25 motor, part #'s and how difficault is it to do? thanks in advance


savage 14
smojoe
10-09-2005, 03:31 PM
http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXFRD5&P=7 (I'm pretty sure thats the one)

I remember RCCA had a few articles on replacing pistons and sleeves. Sorry I can't give you anything specific
savage 14
10-09-2005, 04:10 PM
thanks alot :thumbsup:, also wat will i need to do this piston, sleeve anything else??
BDKesling
10-09-2005, 08:14 PM
I think this is a decent write up, I may rebuild my savage this winter.
Brian

http://www.nitromonkey.com/enginerebuild.shtml
savage 14
10-09-2005, 10:50 PM
thanks alot
savage 14
10-10-2005, 03:26 PM
from what ive gathered i think i need a piston, piston sleeve, and head gaskets/shims but im not sure about the shims could someone tell me if i need the gasket/shims? thanks
savage 14
BAR 26
10-10-2005, 08:09 PM
YOU NEED NOTHING!!!!! LOL J/K its about time you rebuilt that LOL!!!!!!! look in the manual i would think that has part #'s, if its not to much call me i might rebuild mine too, then we'll both have fresh engines to get mark LOL,

C ya later
BAR 26
savage 14
10-10-2005, 09:43 PM
ya i know about the part #'s i thought of that after i posted this but im not sure about the gaskets under the head.

sav.14
savage 14
10-14-2005, 06:20 AM
dose any one know if i need to change the gaskets i think i do but i would like someone who has done this before to let me know

thanks sav.14
savage 14
10-14-2005, 04:44 PM
dose any one know if i need to change the gaskets i think i do but i would like someone who has done this before to let me know

thanks sav.14


my dad got instructions from the hobby shop we use for parts and i now know how to rebuild it thanks to all who replied!
2mcgrath
10-18-2005, 01:40 PM
i have seen the piston and sleeve set on ebay go for around $50 bucks or so..also on the gaskets i dont ever change mine unless there was a problem before with them..only one i change after a rebuild is the header gasket.just check your head gastket and make sure it is sealing good along with the backplate
t4racer
10-21-2005, 03:06 AM
I went the route u are going with my tmaxx but the second time I went to rebuild I sent them off to get repinched. It cost me 15 bucks and it turned out better than new. I love the motor now. More punch and alot cheaper