Hey. The rear CVD where it connects to the hub is quite loose, I took the wheel off and I can pull the screw the wheel connects to in and out a fair bit, definately way too much play. How do I fix this? Also, the front end keeps coming apart, I have already had to buy a new front end and even with the new front end, the skid plate screws just keep ripping out, it seems like the graphite just doesn't hold good, I am thinking of getting plastic.

oh, I was wondering if these would help with the front end coming apart- http://cgi.ebay.com/team-losi-xxx-t-xxxt-matt-francis-aluminum-front-pivot_W0QQitemZ5997588682QQcategoryZ44029QQssPageN ameZWDVWQQrdZ1QQcmdZViewItem, but how does it fit in the front end?

Get some blue or green loctite to secure the small set screw on the CVD
What vehicle do you have again?
If it is a XXXT, It is not uncommon for the front flat head screws to come out in the front. Go to a hobby shop and get a little longer screw. Get 4-40 X 1/2" or 5/8"

Sounds to me like you need a wider spacer or a couple shims between the axle pin and bearing. And do what DJ1978 said to the front skidplate.

I looked on the CVD, can't find the small set screw. Yes, I have a XXX-T.