I Have A 19.5 Briggs Sears Rider Will Not Run No Fuel. Changed Gas Filter Rebuilt Carb And Made Sure Line And Tank Was Not Cloged Any More Ideas Would Be Thankful

try gas down the carb throat.....that or ether/starting fluid.....to see if it runs....then move on to a carb adjustment. both needles all the way in snug not hard in, then 1.5 turns out then adjust..... if nothing, pull the kill wire and try. if it starts then, a switch somewhere is bad....also you'll have to pop the plug wire off to kill it.

Make sure you don't have a pin hole in the fuel line. A hole or crack in the line can prevent the fuel pump from pumping gas to the engine.

.....

Travis Smith;
There is a tab at the top of the forum titled New Thread go there. Have a good one. Geo

Are you sure you assembled the fuel pump correctly?

Are you sure you assembled the fuel pump correctly?

The original post in this thread is about 3 years old.