Howdy folks. This began as a project for another modeler who wanted a stand for 22" Enterprise model. As the job neared completion, we decided that his purposes would be better served by the simple delta that I've posted as the "MKIII" stand on the sci-fi board. I decided to continue on with the original project and offer it here.

This is basically a 70% size version of the big stand I offer for the 1/350 refit (minus the support arm).

You can use it "as is" for a number of Trek related purposes. Or, you can finish it yourself for a model...or I will finish it for you.

http://img65.imageshack.us/img65/1825/mkii1mq.jpg (http://imageshack.us/)

The stand seen in the photo has a 9 3/8" diameter disc and the delta is 14.5" long at it's longest dimension. It has an interior cavity to allow for routing of wires.

The paint is about three coats of lacquer over two coats of primer and sealer. The paint job is very neat and clean. I purposely allow some texture to remain, however. I don't try to polish them to glassy smoothness because that would just highligh any handling marks like scratches or smudges that might arise over a long period of display. I liken the finish to cast metal that you might see on a car intake manifold.

I figure I can offer the item as seen for a total of $39.00US delivered. That's about $30.00 for my work and I estimate maybe $9.00 for shipment to the U.S. (I'm in Canada).

I can also offer any required extras:

OPTION 1) Hole or holes drilled to your specification. No Charge.

OPTION 2) Solid display arm, painted with drilled mounting holes: $10.00 extra.

OPTION 3) Hollow display arm with conduit for wiring, painted with drilled mounting holes:$15.00 extra.