Have a older nitro tc03 and am putting the version 2 Rear end conversion in. Everything went fine till I tried to screw the pivot ball into the suspension arm to find out that that hole is too large and the pivot ball just slides in. I just thought someone else might have had this problem. All the hobby shops are close till Monday and i just wondered. :confused:

im kinda lost. does it go right thrugh the hole?
the cap holds it tight when you put the 4 screws on, or at least it should. dont screw the pivot ball in and stop there. it needs the cap to hold the ball steady. also dont screw the cap down too tight, in needs to be able to pivot. the hub, in a way, is free floating over the pivot balls.