My xapper seems to only zap about 2 cells before it quits. By quit i meen that when i first start it up i put the cell in, hold down the charge button until it gets to about 70 volts, let go of the charge button and the cap. volatge stays there until i hit the discharge button for the first 2 cells. After that when i hit the charge button again for the 3rd cell, the cap voltage goes straight to 89 volts, and when i let go of the button it goes back to 0 volts instanly. Am i doing something wrong. I've even tried zapping 1 cell and waiting on the cap voltage to return all the way to zero before doing the next one, still can't do more than 2 cells no matter what i try. Thanks for any help with this.

Did you try contacting the manufacture?

I had a zapper also and never had that problem. Always built the colts up but would goto 0 instantly.

Are your cells all discharged?

Might have had something go inside to were it might only let you do a few before it cuts out or over heats.

mc

I have the same zapper and haven't had a problem with it. Maybe you should check the fuses.

Thanks for getting back to me. I contacted integy and they said that maby my power supply is putting out more voltage than it should. Its 25 amps but is putting out almost 15 volts. I thought it would be ok to use cause i run 2 turbos and a integy charger with no problem. Looks like this ones going back for repairs. Thanks again for your help.