Anybody got set up tips for this one? Does anyone have a blank setup sheet?
Just got one to run this year and appreciate any input.

Todd can give you the basics for sure :thumbsup:.

Already spoke with Todd when I picked it up. Figured I'd try and get some other feedback from others too.

Does anybody have a pic on midmoutning the motor? I have my first custom works intimidater and cant figure out how get the tie rods of the rear bearing carriers to line up. Any information is greatly appreciated.

WogDog3...go over there http://www.customworksrc.com/aa_support/support01.php ...clisk on the "link" for the Intimidator GBX manual...plenty of pictures and "how to's" for mid motor configuration.

Eric
team CW


ps...it is on page17