Montoya1
01-27-2005, 06:46 PM
what would happen , to the motor and the car it was in, if the magnets in a typical can motor were replaced with ones made of neodymium?
Cheers - deane
Cheers - deane
|
View Full Version : what would happen. Montoya1 01-27-2005, 06:46 PM what would happen , to the motor and the car it was in, if the magnets in a typical can motor were replaced with ones made of neodymium? Cheers - deane doctorslotcar 01-27-2005, 08:54 PM Idunno joez870 01-27-2005, 10:06 PM Speculation: It would go like hell & prolly get kinda hot. Rawafx 01-28-2005, 08:56 AM A stock arm will not have the ability to "match up" to the increased power of the magnets. You'll need to use a hotter arm with a lower OHM resistance. The stock arm will run hot and prbably burn up. Bob Weichbrodt Rawafx A and H Hobbies W-S, NC roadrner 01-28-2005, 11:44 AM Can you say smoke? You could always waste a chassis in a test to enjoy the experience. Everyone needs to fry a chassis at least once. ;) rr vBulletin® v3.8.7, Copyright ©2000-2012, vBulletin Solutions, Inc.
|