I'm looking for some advice about 19T 1/12 scale!I would like to know how many amps should a Chemeleon 2 pull at 2volts with a 4 blade fan!on adjustable timing motors what should i set the amp draw at when using the 4 blade fan at 2 volts!Whats a good rollout on a 75x36 track!

When it comes to 19 turn a chamelon i ran this past weekend in Erie was pulling 7.9 amps at 1.5 volts. I ran a Adustable 19 turn and it pulled 9amps at 1.5 volts. 19 turn will not run your cells down as fast as say a 10 turn. I actually run the same kinda cells for 19 turn as i do for stock, So with this you can crank as much timing as you want in the motor. Runtime now is not a problem.

We run 5 minute 19 turn, and you can't run your shorted stock packs and live, so runtime is a problem here.I make sure my motors are drawing over 3 volts at ZERO degrees timing, then crank in 24 degrees and go racing. I don't check it after putting timing in because with the timing, it's just arcing and causing undue wear.
I have no info on the Lizzard, sorry.

Later, Bret

I should state this is for road course 8 minutes!

about 7 to 8 amps gear wise realy depends on the layout because you want to be fast on the straight and in the infield. start about a 30/98 and see how the car feels if it comes on hard at the end of the straights drop a thooth.

is that with a 4 blade fan and at what volt!What would the rollout be in inches!Example(1.67) with a 1.80 tire

4 blade fan 2 volts roll out for the gear I told you with a 1.8 rear tire is 1.90.

oops sorry , I see its 1/12th

1/12th scale 19t road course